Helder 2 face / skin protocol — 20–30 cm · 10 min per session · Head mode

DeviceHelder 2 (AriHelder)
Distance20–30 cm
ModeHead mode · half power
Duration10 min per session
FrequencyDaily or 5× / week
Wavelengths631 nm red · 856 nm NIR
✓ OHSP Verified Verified output: 10.47W total — NIR 9,242 mW + Red 1,228 mW. Independent integrating sphere measurement →

How to position the device

Attach to the arm mount. Position 20–30cm from the face. Sit still and face the device. Close eyes or wear eye protection. Use the head mode exclusively for face protocols.

1

Set up the device

Attach to the arm mount. Position 20–30cm from the face. Sit still and face the device. Close eyes or wear eye protection. Use the head mode exclusively for face protocols.

2

Select head mode

Set to head mode, half power — mandatory for face. Output: approximately 5.2W. Body mode is not appropriate for face proximity.

3

Run the session

Hold position for 10 minutes. Eyes closed or protected throughout. Repeat daily or 5 times per week.

Session guidance

Face protocols address skin rejuvenation, collagen stimulation, acne reduction, and general skin health. 20–30cm distance is appropriate — closer than 20cm is not recommended for the face. Consistency over 4–8 weeks is the standard for skin outcomes.

Safety & contraindications Head mode only — never body mode for the face. Eyes must be closed or protected at all times. Do not use over active skin infections or open lesions.

Frequently asked questions

Head mode only — half power. Body mode (full power) is never used for face proximity.
20–30cm. Do not position closer than 20cm for face protocols.
10 minutes in head mode, daily or 5 times per week. Do not extend to 20 minutes for face protocols.
Approximately 5.2W at half power. Body mode (10.47W) is not appropriate for the face.